|
These power failure lights provide light throughout the home,
office, school, hotel, ect... during power outages. Night light
feature provides sufficient light in room and down hallways late
at night. During power failure mode, three high-intensity white
LED's are driven to full brightness. While still offering the
same features, the EL200 series effectively replaces a 15 amp
receptacle and the EL300 series effectively replaces a 15 amp
single pole switch. Commercial grade models interface with Fire
and Smoke Alarm products. |
The EL100 unit can be operated in Five different modes. NOTE: After installation, the battery reaches maximum
charge in about one week.
Night Light ON
- Press the lens once when
the night light is OFF and the night light will come ON at 25% of
full brightness. In this mode the night light is powered by the
building current.
Night Light OFF
- Press the lens once when
the night light is ON and the night light will power OFF.
Power Failure Light ON
- When building current is
disconnected (e.g., during a power failure), the power
failure light will automatically come ON at 100% of full
brightness and remain lit until the battery is discharged (4
hours at a full charge). NOTE: As the battery runs
out of power, the unit will begin to flash and will continue to do so until
all power is drained from the battery or power is restored.
Power Failure Light OFF
- When the light is ON (and the unit is operating on battery power), press and
hold the lens for 5 or more seconds to manually turn it OFF.
NOTE: You can press and hold the lens again for 5 or more
seconds to turn the power failure light back ON.
Battery Test
- After battery has had a
minimum of 1 week to charge, press and hold the lens for 5 seconds
to switch the unit from building current to battery power,
which turns ON the light at the 100% brightness level. If
the light doesn't come on, the battery is dead or damaged.
Releasing the lens will switch the unit back into normal operation.
The EL500 unit can be operated in Six different modes.
All of
the above plus
Smoke Alarm Signal ON - When the EL500 receives a
signal
from a connected smoke alarm or security system,
the power
failure light will flash ON and OFF continuously
at one-second
intervals until the alarm signal is removed, or
until the battery is
drained (4 hours for a fully charged battery).
|
Cat # |
Description |
Spec's |
Quantity Discount |
Purchase |
| EL100 |
In-Wall Power Failure Light |
View |
1-11 $32.25 |
12+ $30.63 |
|
| EL500 |
Commercial Grade |
View |
1-11 $38.70 |
12+ $36.76 |
|
| EL500E |
Commercial Grade with Red Chevron Lens |
View |
1-11 $38.70 |
12+ $36.76 |
|
|
 |
Cat # |
Description |
Color |
Quantity Discount |
Purchase |
| EL200IV |
Power Failure Light with
Receptacle |
Ivory |
1-5 $32.25 |
12+ $30.63 |
|
| EL200LA |
Power Failure Light with
Receptacle |
Light Almond |
1-5 $32.25 |
12+ $30.63 |
|
| EL200WH |
Power Failure Light with
Receptacle |
White |
1-5 $32.25 |
12+ $30.63 |
|
|
 |
Cat # |
Description |
Color |
Quantity Discount |
Purchase |
| EL300IV |
Power Failure Light with 1
Pole Switch |
Ivory |
1-5 $32.25 |
12+ $30.63 |
|
| EL300LA |
Power Failure Light with 1
Pole Switch |
Light Almond |
1-5 $32.25 |
12+ $30.63 |
|
| EL300WH |
Power Failure Light with 1
Pole Switch |
White |
1-5 $32.25 |
12+ $30.63 |
|
|
Click on Pictures For Pricing and
Product selection |
|
|
|
|
|
|
|
|
Intermatic Home Page
Deck Lighting
Flood Lighting
In-Use Covers
Surge Protectors
Spring Wound Timers
Tear and Bollard Lights
Timer Home Page
Transformers and Wire
Air Circulator
AirKing
Aladdin Light Lift
Bath Fans
Central Vacuums
Circuit Breaker
Electrical Tape
Electric Heaters
Fire Stop
Floor Box
Generator Transfer
Hand Dryers
Hand Held Radios
Humidifiers
Lighting Ballast
Lighting Fixtures
Lutron Dimmers
Motor Control
Nylon Ties
Pass and Seymour
Phone Alert
Range hoods
Roof De-Icer
Warm Tiles
Wire Nuts
|
